Aluminum Boat Best Shape Buoyancy Buoyancy: How To Best Construct A Boat Out Of A Small Square Of Aluminum Foil.?
Buoyancy: How to best construct a boat out of a small square of aluminum foil.? - aluminum boat best shape buoyancy
If they have 1 foot square of paper, how to best aluminum foil on a boat-shape given the greatest weight in the chamber is placed in water?
http://www97.intel.com/en/ProjectDesign/ ...
http://www.new-sng.com/foilboat.cfm
http://pbskids.org/zoom/activities/sci/b ...
|
5 comments:
All I could find was this "The best drawings are flat barges with small parts." Http: / / www.nps.gov / miss / forte achers / brjr ...
I built two models that looked good, with 1 square heavy duty aluminum foil. One of them was holding an origami box £ 0.74. Two had a cone shape instead of EUR 0.70.
Comment:
1) http://hobbies.expertvillage.com/videos/ ... or
2) http://answers.yahoo.com/question/index ...
Discuss the film in a concave shape, it floats.
It is necessary to try to maximize two things at once:
1. The volume contained in the vessel
2. The height of the walls above the floor of the boat.
The form gives you the best of both is a floating continent of concave-up, but the edge of the hemisphere above the water. Of course, the smallest imbalance and be turned on its side, allowing water to give
a region that contains most of the smallest space possible, would therefore form a hemisphere. This will push as hard as possible.
Design the shape of the leaves to replace more water. This form will receive the most weight. It is not sure how it is.
Post a Comment